Modified on: Tue, 25 Jun, 2019 at 5:40 PM
1. Program the 5804BDV in Zone Programming mode as usual.
2. After programming the unit, exit Zone Programming mode.
3. Enter Go/No Go mode at the control panel (see the control panel Installation Instructions for specific information.)
4. Press and hold the “B”, “C”, and “D” buttons at the same time until the unit’s red and green LEDs flash alternately.
The 5804BDV transmits a special signal to the receiver. After 2 seconds, the unit will shut down. The unit is now in HighSecurity mode. After activating High-Security mode, Whenever a button on the unit is pressed, the left yellow LED flashes to indicate that the unit is in High-Security mode. If the left yellow LED does not flash when a button is pressed, repeat steps 3 and 4 above.
If you are looking to reduce your monthly alarm monitoring rates for your home or business make sure to contact GEOARM Security at 1-877-443-6276 for your free consultation! *We are usually able to takeover just about any kind of security system so don’t hesitate.
Did you find it helpful?Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.
Do You Have any Discussion Questions?
comments powered by Disqus