Modified on: Tue, 25 Jun, 2019 at 5:45 PM
To test the Honeywell Lyric controller zone programming you will be using a mode called RF Sniffer Test. To perform the Lyric controller RF sniffer test from the home screen select Security > Tools > enter you installer code "default is 4112" > Test > RF Sniffer Test.
This Lyric Controller mode is used after all 5800 and SiX transmitters have been entered to check that they have been properly programmed.The Lyric keypad will display all zone numbers which have a non-zero zone type (even zones where the Serial Number has not been programmed yet). Fault each transmitter in turn, causing each one to send a signal. As the system receives a signal from each of the transmitters, all zones associated with that transmitter will disappear from the display.
The transmitters may be checked upon installation, or in an installed system. The panel will not exit Sniffer mode automatically, you must enter the Installer Code to exit this mode. The Lyric controller default installer code is 4112.
If you are looking to reduce your monthly alarm monitoring rates for your home or business make sure to contact AlarmClub at 1-844-335-5897 for your free consultation! *We are usually able to takeover just about any kind of security system so don’t hesitate.
Alarm Monitoring Services
Honeywell Lyric Controller FAQ’s
Honeywell Lyric Controller Manuals
All Honeywell Lyric Security System Video's Playlist :
Did you find it helpful?Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.
Do You Have any Discussion Questions?
comments powered by Disqus